The following configuration parameters are used to configure VLAN functionality on the network switch internal to the phone.
Parameter name
Default value
Description
L2Q
0
Specifies if layer 2 frames generated by the telephone have IEEE 802.1Q VLAN tags.
Value operation:
L2Q is configured through:
Local admin procedure
A name equal to value pair in DHCPACK message
SET command in the Settings file
DHCP option 43
LLDP
VLANTEST
60
Specifies the number of seconds that the phone waits prior to failing back to a different VLAN ID if no response is received from the DHCP server.
Valid values are 0 through 999.
Value operation:
VLANTEST is configured through:
Settings file
A name equal to value pair in DHCPACK message
VLANSEP
1
Specifies whether the VLAN separation is enabled or disabled by the built-in Ethernet switch.
Value operation:
VLANSEPMODE
1
Specifies whether the VLAN separation is enabled or disabled.
Value operation:
VLANSEPMODE is configured through the Settings file.
PHY2TAGS
0
Determines whether or not VLAN tags are stripped on Ethernet frames going out of the Computer (PC) port.
Value operation:
PHY2TAGS is configured through the Settings file.
L2QVLAN
0
Specifies the voice VLAN ID to be used by IP phones.
Valid values are 0 through 4094.
L2QVLAN is configured through:
Local admin procedure
A name equal to value pair in DHCPACK message
SET command in the Settings file
DHCP option 43
LLDP
PHY2VLAN
0
Specifies the value of the 802.1Q VLAN ID used by frames forwarded to and from the secondary (PHY2) Ethernet interface when VLAN separation is enabled.
Valid values are 0 through 4094.
PHY2VLAN is configured through:
SET command in a settings file
LLDP
L2QAUD
6
Specifies the value of the VLAN priority portion of the VLAN tag when the phone generates tagged Ethernet frames from the internal CPU of the phone. These values are inserted into the VLAN tag for audio frames (RTP, RTCP, SRTP, SRTCP). All other frames except those specified by the L2QSIG parameter are set to priority 0.
Valid values are 0 through 7.
L2QAUD is configured through:
SET command in the Settings file
LLDP
L2QSIG
6
Specifies the layer 2 VLAN priority value for signaling frames generated by the phone.
Valid values are 0 through 7.
L2QSIG is configured through:
SET command in the Settings file
AADS
LLDP
Setting this parameter through AADS or LLDP overwrites values in the settings file.
PHY2PRIO
Specifies the layer 2 priority value to be used for frames received on the secondary Ethernet interface when VLAN separation is enabled. The parameter is not supported when VLANSEPMODE is 1.
